Owner's manual

20
6.4 Default Data (factory setting)
stluafeDnoitcnuF
Display Unit of measurement
(Line 1)
Line 2
Line 3
Pressure display (in bar)
Temperature display (in °C)
Sensor’s nominal pressure range (in bar)
Am 4oreznoitarbilaC = nom. pressure range start
span 20 mA = nom. pressure range end
Output Damping
Inversion
Fault
Limits
I-offset
0 s
no
21 mA (upscale)
3.8 ... 20.5 mA
0 mA
drowssap evitca ondrowssap ecivreS
Service mounting correction not activated
hsilgnEeg
augnaL
Evaluation linear
density
yes
1 g/cm
3
Calibrated special measurement ranges i. e. 60 psi on a 100 psi transmit-
ter can be adjusted by factory pre-setting. A reset to default will reset
the sensor back to its nominal range (i. e. 100 psi). The factory pre-setting
gets lost.
Important