Slush Machine Instruction Manual

ENGLISH 5

CLEANING THE UNIT (Continued)

YOU MAY find a need to remove and clean the stainless grinding cage from the inside

base of the tank (trapped citrus pulp, etc.) Refer to the directions below to perform this

function.

REMOVING AND SETTING THE STAINLESS GRINDING CAGE

IT IS VERY IMPORTANT THAT THIS THE STAINLESS STEEL GRINDING CAGE IS

ASSEMBLED PROPERLY FOR YOUR UNIT TO WORK.

1. Inside the unit is a stainless steel grinding cage

and round plastic collar to lock the grinding cage into

place**.

2. Place the stainless steel grinding cage with the

smooth side (opposite of the 3 tab side) into the

plastic collar and twist until the notch of the stainless

steel grinding cage locks into the protrusion on the

plastic collar. (See illustration H).

3. Turn the assembled grinding cage (with plastic cover) over, so black plastic collar is

on the top to insert into the base of tank.

4. Looking down into the interior of the tank, you will see 2

Stainless Steel screws. This is where the clips attached

to the plastic collar lock the grinding mechanism down.

(Illustration H)

5. When putting the collar into position, align the plastic

collar with the tabs with the indented postpositions. With

firm but gentle pressure, press the collar down until the

tabs “click” into place.

6. Once everything is in place, make sure the clips are pushed inward toward the

screws to lock the unit into position, (Illustration H) and lift slightly to insure the cage

is in fact locked into position properly and will not release.

**THIS IS VERY IMPORTANT! IF THE COLLAR IS NOT LOCKED PROPERLY - THE

UNIT WILL GRIND BUT WILL NOT DISPENSE. Lock and unlock clips carefully, to

avoid breaking. Your MARGARATOR™ is now ready to fill with your favorite liquid and

use again.

IMPORTANT:

DO NOT PUT TANK IN DISHWASHER!