All products are trademarks of Nostalgia Products LLC. Worldwide design & utility patented or patents pending. © 2014 Nostalgia Products LLC. www.nostalgia products.com (rev.
RISM900RETRORED Retro Series™ Electric Shaved Ice Machine Máquina eléctrica de granizado de la Serie Retro™ Broyeur de glace électrique de la Série Retro™ Instructions and Recipes Instrucciones y Recetas Instructions et Recettes
CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 IMPORTANT SAFEGUARDS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PARTS & ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 HOW TO OPERATE . . . . .
ENGLISH IMPORTANT PRECAUTIONS 1. NEVER immerse Motor or plug in water. 2. NEVER use near water. 3. NEVER use an abrasive sponge or cloth on the appliance. 4. NEVER use a scouring pad on the appliance. 5. NEVER leave appliance unattended while in use. 6. Unplug unit from outlet when not in use, before placing or removing parts and during cleaning. 7. DO NOT operate this appliance with a damaged cord or plug, nor if the appliance ever malfunctions. 8. DO NOT put in a dishwasher. 9.
Check Shaver Bowl for presence of foreign objects prior to use. 13. DO NOT use the appliance for other than its intended use. 14. DO NOT operate the appliance when the Shaver Bowl is empty. 15. DO NOT place fingers or utensils into feed or discharge areas. 16. DO NOT press the Power Button when Motor is not assembled to Shaver Bowl and Base. 17. After each 1 minute of continuous use, wait 10 minutes before using again to allow motor to cool. 18.
ENGLISH PARTS & ASSEMBLY ASSEMBLY Your RETRO SERIES™ ELECTRIC SHAVED ICE MACHINE requires very little assembly. • The RETRO SERIES™ ELECTRIC SHAVED ICE MACHINE has a sharp stainless steel blade that can cut and cause injury. Use EXTREME CAUTION when handling the appliance. Keep fingers clear from blade and avoid contact at all times when using and cleaning. • Wipe the Motor, Shaver Bowl and Base with a damp, non-abrasive cloth. Dry thoroughly. DO NOT immerse Motor or cord in water.
• Fill a standard ice cube tray or the supplied Ice Molds with water and place in freezer until frozen. Remove ice from tray(s). See HELPFUL TIPS section for instructions on using Ice Molds. • Place the RETRO SERIES™ ELECTRIC SHAVED ICE MACHINE on a stable, waterproof surface near an electrical outlet before starting. • Always make sure that the cord is away from a water source. • With Shaver Bowl fitted on top of Base, place frozen ice cubes in Shaver Bowl.
ENGLISH CLEANING & MAINTENANCE The blades in the Shaver Bowl are very sharp. Use EXTREME CAUTION when handling the appliance during cleaning. • Make sure the unit is unplugged before cleaning. Do not put the Motor in water or any other liquid. • Before first use and continuing after each use, be sure to wipe off the Motor with a damp, non-abrasive cloth and dry thoroughly. Wash the Shaver Bowl, Base and Ice Molds with a soft cloth in warm water mixed with a mild detergent.
ENGLISH RETURNS & WARRANTY SHOULD YOUR UNIT NOT WORK OR IF DAMAGED WHEN YOU FIRST TAKE IT OUT OF THE BOX, PLEASE RETURN IT TO THE PLACE OF PURCHASE IMMEDIATELY. RETRO SERIES™ ELECTRIC SHAVED ICE MACHINE / RISM900RETRORED Should you have any questions, please contact us via email or at the customer service number listed below between the hours of 8:00 AM and 5:00 PM, Monday through Friday, Central Standard Time. Distributed by: Nostalgia Products LLC 1471 Partnership Dr.
¡Haga de cada día una fiesta! Visite www.nostalgiaproducts.com para ver más productos divertidos. CONTENIDO PRECAUCIONES IMPORTANTES . . . . . . . . . . . . . . . . . . . . . . . . . . 10 MEDIDAS IMPORTANTES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 INTRODUCCIÓN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 PIEZAS Y ENSAMBLAJE. . . . . . . . . . . . . . .
PRECAUCIONES IMPORTANTES NUNCA sumerja el gabinete del motor o el enchufe en agua. 2. No lo utilice NUNCA cerca del agua. 3. No utilice NUNCA una esponja o un paño abrasivo con el aparato. 4. No utilice NUNCA un estropajo en el aparato. 5. No deje NUNCA el aparato desatendido mientras esté en funcionamiento. 6. Desenchufe la unidad de la red cuando no lo esté utilizando, antes de colocar o retirar piezas y durante su limpieza. 7.
Revise el recipiente de la máquina para ver si tiene objetos extraños antes del uso. 13. NO utilice el aparato para otro uso que no sea el cual para el que está destinado. 14. NO haga funcionar el aparato cuando el recipiente esté vacío. 15. NUNCA sitúe los dedos ni coloque utensilios en las áreas de alimentación o descarga. 16. NO presione el botón de encendido cuando el gabinete del motor no esté ensamblado al recipiente de la máquina y a la base. 17.
PIEZAS Y ENSAMBLAJE ENSAMBLAJE La MÁQUINA ELÉCTRICA DE GRANIZADO DE LA SERIE RETRO™ requiere muy poco ensamblaje • La MÁQUINA ELÉCTRICA DE GRANIZADO DE LA SERIE RETRO™ tiene una cuchilla de acero inoxidable afilada que puede cortar y causar lesiones. Tenga SUMO CUIDADO cuando manipule el aparato. Mantenga los dedos alejados de la cuchilla y evite el contacto en todo momento al usar y limpiar. • Limpie el gabinete del motor y la base con un paño húmedo, no abrasivo. Seque a fondo.
ESPAÑOL • CÓMO FUNCIONA Llene una bandeja de cubitos de hielo o los moldes de hielo provistos con agua y colóquela en el congelador hasta que se congelen. Retire el hielo de la(s) bandeja(s). Consulte la sección CONSEJOS ÚTILES para ver las instrucciones de uso de los moldes de hielo. • Coloque la MÁQUINA ELÉCTRICA DE GRANIZADO DE LA SERIE RETRO™ en una superficie estable, resistente al agua cerca de una toma de corriente eléctrica antes de comenzar.
LIMPIEZA Y MANTENIMIENTO Las cuchillas en el recipiente de la máquina están muy afiladas. Tenga SUMO CUIDADO cuando manipule el aparato durante la limpieza. • • • Asegúrese de que el aparato esté desconectado antes de limpiarlo. Do coloque el gabinete del motor en agua o cualquier otro líquido. Antes del primer uso y después de cada uso continuo, asegúrese de limpiar el gabinete del motor con un paño húmedo no abrasivo y séquelo bien.
DEVOLUCIONES Y GARANTÍA SI LA UNIDAD NO FUNCIONA O ESTÁ DAÑADA AL SACARLA POR PRIMERA VEZ DE LA CAJA, DEVUÉLVALA AL LUGAR DE COMPRA INMEDIATAMENTE. MÁQUINA ELÉCTRICA DE GRANIZADO DE LA SERIE RETRO™ / RISM900RETRORED Si tiene preguntas, contacte con nosotros por correo electrónico o por el número telefónico de servicio al cliente que aparece a continuación en el horario de 8:00 AM a 5:00 PM, de lunes a viernes, Hora Estándar del Este. Distribuida por: Nostalgia Products LLC 1471 Partnership Dr.
Faites de chaque jour une fête ! Visiter le site Web www.nostalgiaproducts.com pour d’autres produits agréables. TABLE DES MATIÈRES IMPORTANTES MESURES DE PRÉCAUTION . . . . . . . . . . . . . . . . . . . 17 IMPORTANTES MISES EN GARDE . . . . . . . . . . . . . . . . . . . . . . . . . 17 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 PIÈCES ET ASSEMBLAGE . . . . . . . . . . . .
IMPORTANTES MESURES DE PRÉCAUTION 1. NE JAMAIS plonger le compartiment du moteur ou le brancher dans l'eau. 2. NE JAMAIS utiliser près d'une source d'eau. 3. NE JAMAIS utiliser une éponge ou un chiffon abrasif sur l'appareil. 4. NE JAMAIS utiliser un tampon à récurer sur l'appareil. 5. NE JAMAIS laisser l'appareil sans surveillance pendant le fonctionnement. 6.
11. NE PAS placer sur un brûleur à gaz ou électrique ou à sa proximité, ou dans un four chaud. 12. Vérifier qu'il n'y a aucun corps étranger dans le bol de broyage avant son utilisation. 13. NE JAMAIS utiliser cet appareil pour un usage autre que celui auquel il est destiné. 14. NE JAMAIS faire fonctionner l'appareil quand le bol de broyage est vide. 15. NE JAMAIS mettre les doigts ou des ustensiles dans les zones d'évacuation ou de décharge. 16.
PIÈCES ET ASSEMBLAGE ASSEMBLAGE VOTRE BROYEUR DE GLACE ÉLECTRIQUE DE LA SÉRIE RETRO™ nécessite très peu d'assemblage. • LE BROYEUR DE GLACE ÉLECTRIQUE DE LA SÉRIE RETRO™ contient des couteaux en acier inoxydable qui pourrait causer des blessures. Soyez TRÈS PRUDENT pendant la manipulation de cet appareil. Garder les doigts éloignés du couteau et éviter tout contact lors de l'utilisation et du nettoyage. • Essuyer le compartiment du moteur et le socle à l'aide d'un chiffon humide et non abrasif.
MODE D'EMPLOI • Remplir un bac à glaçons ou les moules à glace fournis d'eau et mettre dans le congélateur jusqu'à ce qu'il(s) gèle(ent). Retirer les glaçons du (des) bac(s). Voir la section des CONSEILS UTILES pour les directives sur l'utilisation des moules à glace. • Placer le BROYEUR À GLACE ÉLECTRIQUE DE LA SÉRIE RETRO™ sur une surface imperméable stable, à proximité d'une prise de courant avant de commencer. • Toujours s'assurer que le cordon électrique est éloigné de toute source d'eau.
NETTOYAGE ET ENTRETIEN Les couteaux dans le bol de broyage sont très tranchants. Être TRÈS PRUDENT avec la manipulation de cet appareil pendant le nettoyage. • Débrancher l'appareil avant de le nettoyer. Ne pas immerger le compartiment du moteur dans l'eau ou autre liquide. • Avant et après chaque utilisation, s'assurer de bien essuyer le compartiment du moteur à l'aide d'un chiffon humide, non abrasif puis bien assécher.
RETOUR ET GARANTIE SI VOTRE APPAREIL NE FONCTIONNE PAS OU S'IL EST ENDOMMAGÉ QUAND VOUS LE RETIREZ DE LA BOÎTE, VEUILLEZ LE RETOURNER IMMÉDIATEMENT À L'ENDROIT OÙ IL A ÉTÉ ACHETÉ. BROYEUR DE GLACE ÉLECTRIQUE DE LA SÉRIE RETRO™ / RISM900RETRORED Pour toute question, communiquer par courriel ou au numéro de téléphone du service à la clientèle, entre 08 h 00 et 17 h 00, du lundi au vendredi, heure normale du Centre. Distribué par : Nostalgia Products LLC 1471 Partnership Dr.