Use and Care Manual

ENGLISH

HOW TO OPERATE

Before rst use, clean your BEVERAGE COOLER & WARMER by removing the

shelf and cleaning the cabinet interior and shelf with a slightly damp, non-

abrasive sponge, towel or cloth. Wipe with a non-abrasive towel to dry.

DETERMINE CURRENT TYPE

Alternating Current (AC) - When using unit in a standard 120 volt electrical wall outlet, use

the AC power cord. Plug AC power cord into the designated AC receiver on the back panel.

Direct Current (DC) - When using unit in a 12 volt auxiliary power outlet

(common in cars, trucks, boats, etc.), use the DC power cord. Plug DC

power cord into the designated DC receiver on the back panel.

MODE SELECTION

COLD - Toggle the switch on the back panel to "COLD" to cool the

unit down to 45°F based on an ambient room temperature of 70°F.

When selected, the green indicator light will illuminate.

HOT - Toggle the switch on the back panel to "HOT" to warm the unit up to 130°F based on

an ambient room temperature of 70°F. When selected, the red indicator light will illuminate.

NORMAL MODE: The fan runs at higher speed under normal mode,

it is recommended to select this mode in the daytime.

NIGHT MODE: The fan runs at lower speed under normal mode,

it is recommended to select this mode at night.

BASIC OPERATION

1. Before operating, be sure the power switch is in the OFF position. Attach

the appropriate power cord to the back panel, then plug the other end

of the power cord into the appropriate socket or electrical outlet.

2. Once plugged in, toggle the power switch to COLD or HOT.

NOTE: When alternating between COLD and HOT functions, toggle the

power switch to OFF rst. After 5 minutes, toggle to COLD or HOT.

3. Place beverages or food into unit.

NOTE: For best results, refrigerate or heat items before placing in unit.