Use and Care Manual
ENGLISH
6
HOW TO OPERATE
1. Fill a standard ice cube tray or the supplied Ice Molds with water
and place in freezer until frozen. Remove ice from tray(s). See
HELPFUL TIPS section for instructions on using Ice Molds.
2. Place the ELECTRIC SNOW CONE MAKER on a stable, waterproof
surface near an electrical outlet before starting.
3. Always make sure that the cord is away from a water source.
4. With Shaver Bowl placed on top of Base, place frozen ice cubes in Shaver Bowl. DO NOT
FILL PAST MAX FILL LINE (holds approximately 8 medium-sized ice cubes).
BE CAREFUL when placing ice cubes in Shaver Bowl as the blade in the Shaver Bowl is very
sharp.
5. Place a cone under the Shaver Bowl to catch the shaved ice.
6. Place the Motor Cabinet on top of the Shaver Bowl and hold in place. When lled with
ice, the Motor Cabinet will rest a few inches above the bottom of the Shaver Bowl.
7. Plug unit into an electrical outlet. To begin shaving, hold the Motor Cabinet steady with one
hand and press down on the Power Button.
NOTE: For your safety this unit is equipped with a built-in safety switch.
Ice must be in the Shaver Bowl for the unit to work. When the ice level
gets too low, the safety switch will engage and stop the motor.
8. Push down continuously until majority of ice is shaved, or until the Motor Cabinet sits ush
on the bottom of the Ice Bowl. To stop shaving ice, release pressure on the Motor Cabinet.
9. Some ice may remain in the Shaver Bowl. Discard this ice before adding a new ice cube.
10. Repeat the process until you have the desired amount of shaved ice.
11. After each 1 minute of continuous use, wait 10 minutes
before using again to allow motor to cool.
12. Unplug unit from outlet when nished.
HELPFUL TIPS
USING TRADITIONAL ICE CUBES
• Place 8 medium-sized ice cubes in an even layer in Shaver
Bowl to yield approximately 2 cups of shaved ice.
• Do not overll Shaver Bowl with ice (see max ll line in shaver bowl).
USING ICE MOLDS
Common ice cubes may be used in the SHAVED ICE MACHINE, but will produce slightly
coarser textured ice. For best results, we recommend using the included Ice Molds.
• Fill the supplied Ice Mold with liquid to approximately
½ inch below the top.
• Place on a at surface in the freezer until frozen (about 10 - 12 hours).
• If unable to remove ice from Ice Mold, run under water until ice is loose.
• Ice Mold makes approximately 2 cups of shaved ice.
• Ice Mold may also be used as serving bowls for shaved ice.
Reusable
Snow Cone