Installation Guide

Installation Instructions
For Pre-Attached Long Plates
Passage and Privacy
Door Handing - Long Plates
With step-by-step Installation Pictograms & Drilling Template
Applies to:
Craftsman • Mission • Prairie • Deco • New York • Egg & Dart
Meadows • Victorian
Tools Required: #2 Phillips Screwdriver, electric drill, 7/64” drill bit
Door handing is critical for Split-Finish, or Split-Design products in the privacy function. And, it’s
helpful positioning the latch tongue in relation to the strike plate.
INSTALLATION RULES:
1) Long Plate wood mounting screws should NOT be installed using power tools.
2) Privacy pin holes are next to the door side containing the latch.
3) Latch tongues have a beveled side, and this side should contact
the curved end of the face plate, and curved end of the strike plate.
(See *Latch Tongue Note on page 3.)
Inside of Door - The Inside of a door refers to the side of the door that faces the room. For example,
for a bedroom door on a hallway, the Inside of the door would face the bedroom.
Outside of Door - The Outside of a door refers to the side of the door that faces away from the room.
The Outside of a door is generally more visible to visitors, and therefore a rosette on this side of the
door has no visible screws. For example, on a bedroom door, the Outside would face the hallway.
outside
To identify door handing,
face door from the Outside.
outside
DOORS OPENING INWARD
Hinge is on the left.
Door is Left Hand.
Hinge is on the left.
Door is Left Hand.
Hinge is on the right.
Door is Right Hand.
Hinge is on the right.
Door is Right Hand.
To identify door handing,
face door from the Outside.
DOORS OPENING OUTWARD
outsideoutside
Page 1 - PK175 04202017