Installation Guide
MEASURE FROM THE FLOOR TO THE CENTER OF EXISTING LOCKS,
AND USE THIS DISTANCE AS THE CENTER OF THE DUMMY MOUNT.
IF THERE ARE NO EXISTING LOCKS, POSITION THE DUMMY
MOUNT 36” TO 38” FROM THE FLOOR.
2 FOLD TEMPLATE ALONG DOTTED LINE,
AND POSITION FOLD ON THE EDGE OF THE DOOR.
TAPE TEMPLATE TO FACE OF DOOR.
3 BEFORE DRILLING VERIFY THE
BACKSET OF YOUR EXISTING DOORS
IN YOUR HOUSE. DRILL PILOT HOLES
USING A 7/64” DIAMETER BIT.
4 INSERT THREE WOOD SCREWS,
SLIDE LONG PLATE OVER MOUNT,
AND SCREWON KNOB.
5 ALIGN SIDE
OF LONG PLATE
WITH DOOR EDGE.
6 INSERT
HEX SCREWS
AND TIGHTEN.
FLOOR
DUMMY MOUNT
(1)
TEMPLATE
EDGE OF DOOR
FACE OF DOOR
Page 4 - PK175 04202017