Installation Guide
Measure from the oor to the center of existing locks,
and use this distance as the height of the dummy mount.
If there are no existing locks, position the dummy
mount 36” to 38” from the oor.
2 Fold template along dotted line,
and position fold on the edge of the door.
Tape template to face of door.
3 Before drilling verify the backset
of your existing doors. Mark the
four screw hole positions on your
dummy mount on the template.
Drill pilot holes using a 7/64”
diameter bit.
(4) Remove template from door.
Install four wood screws in
dummy mount.
6 Mark the screw hole positions on
your long plate on the door.
Drill pilot holes using a 7/64”
diameter bit. Install wood screws
in the long plate.
5 Position long plate
over mount, align
side of long plate
with door edge.
7 Slide lever on mount,
press and hold in
position.
8 Tighten hex screw.
FLOOR
DUMMY MOUNT
(1)
TEMPLATE
EDGE OF DOOR
FACE OF DOOR
DUMMY INSTALLATION AND DOOR PREPARATION TEMPLATE - LEVER
TOP TOP
Page 4 - PK# 301 08012019