Installation Guide

For assistance call 800-522-7336 Monday through Friday 7am to 5pm Mountain Time
Page 1 PK #303 08012019
Nostalgic Warehouse
Door Hardware
Installation Instructions
LONG PLATE
PRE-ATTACHED
LEVER
SINGLE CYLINDER HANDLESET
Note: Handlesets fi t doors 1-3/4” to 2” thick.
Push button and hold during
insertion
Insert handleset spindle
silver end rst, in “diamond”
orientation.
Door-Outside
1
2
L
9
10
12
2
11
Door
Jamb
3/4
Install jamb strikeplate.
K
20
22
21
17
Long Plate
19
Lever
1” Oval Head
Wood Screws
*
1” Oval Head
Wood Screws
*
22
21
Bottom Grip
Mounting Screw
Install
long plate
with lever
on door
inside.
Insert
bottom grip
mounting
screw.
J
3 & 4
Cylinder
and Plate
Handlset
(part# 16)
Install
exterior
handleset
on door
exterior.
MAKE SURE GOLD
END OF SPINDLE
IS IN “SQUARE”
ORIENTATION.
(see previous
panel)
silver
gold
Spindle orientation note
DIAMOND
ORIENTATION
SQUARE
ORIENTATION
Silver end of spindle must be in
“Diamond” orientation while initially
inserting into latch.
Once silver end of spindle is inserted,
the gold end should be rotated to
“Square” orientation before the spindle
is completely inserted.
H
I
Insert handleset spindle
IMPORTANT: SEE SPINDLE ORIENTATION NOTE IN NEXT PANEL.
7
8
G
Attach
thumbturn
assembly
with provided
screws.
Door Inside
3
5
6
Cylinder
Assembly
2-3/8”
F
Place cylinder
assembly with
plate on
door exterior.
Attach
deadbolt
adaptor plate
with provided
screws.
3C
3
4
Plate
E
Install cylinder into plate
D
Deadbolt latch tongue note
Bevel Side
Face Plate Curve
Strike Plate Curve
C
Bevel side of latch tongue should contact curved
side of face plate, and curved side of strike plate.
Latch tongue note
14
14
2
2
13
13A
Tongue
Tongue
(See D Below Before
Deadbolt Latch
Installation)
(See Latch
Tongue Note
in Panel C)
3/4”
3/4”
B
Install
deadbolt and
handleset
latches.
USE INCLUDED DOOR PREPARATION
TEMPLATE FOR NON-PREPPED DOORS.
USE INCLUDED PLASTIC TEMPLATE TO
LOCATE AND DRILL THE 1/4” BOTTOM GRIP
MOUNTING HOLE. (See note on reverse side.)
A