Instructions / Assembly

be drilled. Hint: If you cannot see the bolt clearly, or cannot
mark the jamb with a pencil because the door is closed, you
can cover the end of the bolt with a light amount of lipstick or
similarly visible material. When you turn the key, the lipstick
will mark the door jamb.
B) U
sing a 7/8” drill bit, drill two holes centered 5/16” above
and below the center mark. These holes will overlap. Make
sure each one is at least 1-1/8” deep.
C) Clean out the hole (if needed) and insert the black dust box
(Part #10). Close the door carefully, making sure not to crush
the dust box. Make sure that the deadbolt and dust box line
up. If not, carefully enlarge the hole as needed.
D) Using the strike plate (Part #13), mark the area to be mortised
out for the dust box (Part #10), door frame reinforcer (Part
#11), and strike plate. Use a chisel to mortise this area and
make sure that once assembled, the strike plate sits flush to
the door jamb.
E) Place the door frame reinforcer over the dust box. Using the
door frame reinforcer as a guide, find the holes closest to the
outside of the house and drill two 7/64” x 3” deep holes for
the reinforcer screws.
F) Install the 3” wood screws (Part #12). Again, check to make
sure the deadbolt and reinforcer line up and that the deadbolt
can be locked.
G) Drill two 7/64” x 3/4” deep holes for the strike plate and
install the strike plate using the 3/4” latch and strike wood
screws (Part #3).
Congratulations! You are now
on your way to enriching your
life with !
Page 4 - PK158















Figure #9