Specification

Installation Instructions
For Restoration
Long Plates
Passage & Privacy
Fits doors
1-3/8” to 1-3/4” thick
For 2-3/8”
Backset:
For 2-3/4”
Backset:
Backset
Information
NOTE:
DRILLING TEMPLATES
FOR PILOT HOLES
ON SEPARATE
INCLUDED SHEET
Door - Outside
Install
Latch
Install latch and rotate
the latch tongue
to change handing.
(See page 1 for handing)
Install faceplate with
3/4” wood screws.
1
2
*
*
Latch Tongue Note
Bevel Side
Face Plate Curve
Strike Plate Curve
Bevel side of latch tongue should
contact curved end of face plate,
and curved end of strike plate.
Strike Plate Curve
Strike Plate Curve
Insert Spindle
Emergency
release hole
(Privacy only)
Install Exterior Plate Install Bushing & Knob
3
3
See Latch Tongue
Note in next panel
*
Tighten Hex Screws
Insert both
hex screws
and tighten
Insert wood screws
Install
Interior
Plate
J
Install
Bushing
and
Knob
Screw in
privacy pin
(Priacy only)
K
Insert
wood
screws
Insert both
hex screws
and tighten
NOTE:
If knobs do not turn freely;
loosen one knob and rotate
counter clockwise for
1/4 turn, then retighten
the hex screws.
Repeat if necessary.
Need help? Please Call us at
1-800-522-7336
Monday–Friday
7am–5pm Mountain Time
or visit
www.NostalgicWarehouse.com/support
L
Tighten
Hex
Screws
Page 3 - PK107L 04262017