User's Manual

NOTE:

- If you need to re-assign the sensor channel, slide the channel slide switch to the new channel

position. For the new channel number to be effective, press [ RESET ] key on the sensor.

- Avoid placing the sensors in direct sunlight, rain or snow.

- To avoid the sensor/s and console pairing failure during new console setup, please power up

the sensor/s rst, and then press [ RESET ] key on the main unit (no need on sensors).

PLACING THE WIRELESS INDOOR SENSOR

Place a screw on the wall that you wish to hang the sensor on.

Hang the sensor onto the screw by the wall mounting holder. You

can also place the sensor on a table by itself.

SETUP THE CONSOLE

POWER UP THE CONSOLE

1. Plug the adapter provided to the power jack at the back of the console.

2. Once the console is turned on, all the segments of the LCD will be shown momentarily.

3. The console will automatically enters sensor synchronization mode and AP mode (refer to

SETUP WI-FI CONNECTION).

NOTE:

If no display appears on the LCD after you plug the adaptor, press [ RESET ] key by using a

pointed object.

SYNCHRONIZING WIRELESS 7-IN-1 SENSOR AND INDOOR SENSOR(S)

Immediately after power up, while still in Synchronization mode, the 7-in-1 sensor and Indoor

Sensor can be paired to the console automatically. Once your sensors are paired up, the

sensors' signal strength indicator and weather reading will appear on your console display.

BACKUP BATTERY

Backup batteries are used to keep time-sensitive information on the console’s memory during

power failure. These include:

- Time & Date, Alarm Time, Max/Min & Past 24 hours weather records, Alert setting values,

Sensor(s) channel history, and Units

1. Remove the battery door of the console.

2. Insert 3 new AAA batteries as per the polarity indicated,

3. Replace the battery door.

BUILT-IN MEMORY

The console has built-in FLASH memory that holds the vital settings. These include:

- Time Zone, DST status, Time SYNC status, WI-FI and Weather server setting, Latitude /

Longitude, Hemisphere setting, Calibration values, and Sensor ID of paired sensor(s)

RESET AND FACTORY HARD RESET

To reset the console and start again, press the [ RESET ] key once. To hard reset the

console and resume factory settings, press and hold the [ RESET ] key for 6 seconds