User's Manual

RESYNCHRONIZE SENSORS

Press the [ SENSOR / WI-FI ] key once for the console to enter sensor Synchronization

mode, and the console will re-register all the sensors that have already been registered to the it

before. i.e. the console will not lose the connection of the sensors that you’d paired up before.

CHANGING BATTERIES AND MANUAL PAIRING OF SENSOR

Whenever you changed the batteries of the wireless indoor or 7-in-1 weather sensor, re-

synchronization must be done manually.

1. Change all the batteries to new ones in the sensor.

2. Press [ SENSOR / WI-FI ] key on the console to enter sensor synchronization mode.

3. Press [ RESET ] key on the wireless indoor or 7-in-1 weather sensor.

SYNCHRONIZING ADDITIONAL WIRELESS SENSOR(S) (OPTIONAL)

The console can support up to 7 additional wireless sensors.

1. Press the [ SENSOR / WI-FI ] key once on the console to enter synchronization mode.

2. Press the [ RESET ] key on the new sensor, and wait for a few minutes for the new sensor

to paired to the console.

NOTE:

- Channel number of the indoor sensor must not be duplicated among the sensors. Please refer

to “INSTALL WIRELESS INDOOR SENSOR” for details

- This console can support different type of additional wireless sensor, e.g. soil moisture and

pool sensor. If you would like to pair up additional sensors, please check with your retailer for

more detail.

POINTING THE WIRELESS 7-IN-1 SENSOR TO SOUTH

The outdoor 7-IN-1 sensor is calibrated to point to North for the maximum accuracy. However,

for the user's convenience (e.g. users in the Southern hemisphere), it is possible to use the

sensor with the wind vane pointing to South.

1. Install the 7-IN-1 wireless sensor with its wind meter end pointing to South. (Please refer to

INSTALLATION OF THE WIRELESS SENSOR section for mounting details)

2. Select "S' in hemisphere section of the setup UI setup page. (Please refer to SETUP THE

WEATHER SERVER CONNECTION section for setup details)

3. Press

Apply

icon to conrm and exit.

NOTE:

Changing the hemisphere setting will automatically switch the direction of the moon phase on

the display.

CREATE WEATHER SERVER ACCOUNT & SETUP WI-FI CONNECTION

The console can upload weather data to WUnderground and / or Weathercloud through WI-FI

router, you can follow the step below to setup your device.

NOTE:

The Weather Underground and Weathercloud website are subjected to change without notice.

CREATE WEATHER UNDERGROUND ACCOUNT

1. In https://www.wunderground.com click the "Join" on the top right corner to open the

registration page. Follow the instructions to create your account.

NOTE:

Use the valid email address to register your account.