User Manual

Transceiver Daisy-Chain Installation

(B127A-110-BH only)

8. Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the

B127A-111-BHTH receiver unit to the RJ45 INPUT port on

B127A-110-BH.

9. Connect a monitor to the HDMI OUTPUT port on the

B127A-110-BH that you just added using a Tripp Lite

P568-Series HDMI Cable.

10. Connect the external power supply to the B127A-110-BH

and plug it into a Tripp Lite surge protector, power

distribution unit (PDU) or uninterruptible power supply

(UPS). The green power LED and the green RJ45 LEDs will

illuminate to indicate the unit is receiving power.

11. To add a second B127A-110-BH, repeat steps 8 through

10. To ﬁnish your installation with a B127A-110-BH,

proceed to step 12.

12. Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the

last B127A-110-BH to the RJ45 INPUT port.

13. Connect a monitor to the HDMI OUTPUT port on the

B127A-110-BH using a Tripp Lite P568-Series HDMI Cable.

14. The green LED on the B127A-110-BH will illuminate to

indicate the unit is receiving power from the previous

transceiver. The orange LED will illuminate to indicate the

unit is connected to a powered ON remote/repeater unit.

15. Turn on the power to the HDMI source. The orange RJ45

LEDs on the local unit will illuminate to indicate a signal is

being received from the source.

20-10-008-933D27-Book.indb 2220-10-008-933D27-Book.indb 22 4/21/2021 4:00:30 PM4/21/2021 4:00:30 PM