User Manual

24
USB/IR/Toslink Controls
The extender kit provides the following functional controls:
• USB 1.1 – One Micro-USB input at transmitter, dual USB-A
outputs at receiver
• Bi-Directional IR – Dual 3.5 mm jacks at both the transmitter
and receiver
• Toslink output at receiver and transceiver
(Optional) Connect the included IR-OUT cable to the transmitter
unit’s IR-OUT port. Place the sensor on the IR-OUT cable in
an unobstructed area within clear view of the device being
controlled. Then connect the included IR-IN cable to the receiver
unit’s IR-IN port. The IR-IN cable will communicate the desired
command via the transmitter’s IR-OUT cable.
Note: The IR-OUT cable receives the signal from the remote control and
sends it to the device being controlled (e.g. Blu-ray player, etc.).
(Optional) With a user-supplied USB Micro-B cable (such as
Tripp Lite U050-XXX Series USB cable), connect to the
transmitter’s Micro-B port. Then connect a keyboard and mouse
to the available USB-A ports on the receiver unit.
(Optional) Using a Toslink cable (such as Tripp Lite A102-XXM
Series cables), connect the Toslink cable to a set of speakers, an
audio receiver or other audio system equipped with Toslink digital
outputs.
20-10-008-933D27-Book.indb 2420-10-008-933D27-Book.indb 24 4/21/2021 4:00:30 PM4/21/2021 4:00:30 PM