User Manual

To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support

1. Lower the Media Shelf (K) Assembly from above into the

Supporting Blocks, located on the insides of the Columns

(E+F). Align the holes in the Support Bar (O) with the holes

in the Supporting Blocks. (Figure 10)

2. Insert one M6 x 25 mm Hex Head Screw (V) through the

hole in the Supporting Block on the Left Column (E) and

into the Support Bar (O).

3. Tighten the M6 x 25 mm Hex Head Screw (V), using the

Hex Key (B1).

4. Repeat steps 2-3 for the Right Column (F).

5. Determine the desired mounting height for the Media Shelf

(K) Assembly.

6. Hold the Media Shelf (K) Assembly and loosen the two M6

x 25 mm Hex Head Screws (V) that secure the Support

Block to the Left Column (E), using the Hex Key (B1).

Note: Continue to support the weight of the Media Shelf (K)

Assembly until all of the M6 x 25 mm Hex Head Screws (V)

have been tightened.

7. Repeat step 6 for the Support Block in the Right Column

(F).

8. Slide the Media Shelf (K) Assembly up or down to the

desired height.

9. Tighten all four Support Block Hex Screws, using the Hex

Key (B1).