Installation Guide

AirSpeed 1000 Installation Guide
DUG01289 Airspan Commercial and Internal Use 21
The following describes the pole mounting procedure:
1. Select the location on the pole to mount the AirSpeed 1000 mounting bracket.
Note: You can attach the unit to any pole from 1 inch to 8 inch (33.7 to 210 mm) in diameter.
2. Assemble the 2 SEMS screws (M8 x 20) into the lower threaded holes on the mounting
(base) bracket, do not tighten.
3. Position the mounting bracket onto the pole at the required height using the provided U–
bolts (for 1 in. / 33.7 mm to 1.5 in. / 48.3 mm) pole and tighten in place.
4. Carefully align and position the unit so that the screws (1 on each side) fit into the notched
grooves provided on the back bracket (pre-assembled on the unit) and hand tighten. Insert
the M8 screws, washers and nuts (supplied) and fasten the back bracket (pre-assembled on
the unit) to the mounting bracket.
5. Adjust the unit so that the GPS is positioned upright. Check and tighten all fixing screws.
4.2.1 Pole Mounting (Larger Poles)
Note: For larger 1.8” (45 mm) to 8” (210 mm) poles.
1. Select the location on the pole to mount the AirSpeed 1000 mounting bracket.
2. Assemble the 2 SEMS screws (M8 x 20) into the lower threaded holes on the mounting
(base) bracket, do not tighten.
3. Position the mounting bracket onto the pole at the required height.
4. Insert the clamp bands (supplied) by passing them through the upper and lower slots in the
bracket, in two (2) places.
5. Tighten the clamp bands with a large screw driver.
6. Continue with Steps 4 & 5 as shown above.