Installation Guide

AirStrand 1300 Installation Guide
DUG01370-SP Airspan Commercial and Internal Use 17
3 Verifying Prerequisites
Prior to installing the AirStrand 1300, verify the required safety, power, tools, parts and components.
This chapter includes the hardware, software, and client requirements for installation.
Important: Set up requirements for the installation is detailed in the Job Sheet, see Appendix A.
3.1 Verifying Site Requirements
To set up the AirStrand 1300, an IP connection to a Netspan server is required.
3.2 Verify Installation Requirements
3.2.1 Verify the Tools
Table 4. Minimum Hardware Requirements
Tool
Use
9/16 inch wrench
Tightening hanger 3/8-16 bracket nuts
1/2 inch wrench
Tightening hanger 5/16-18 bracket screws and
nuts
#10 (5/32) Allen wrench
For adjusting the GPS slide screws
Philips screw driver
Good to have
Torque screwdriver
Tightening screws
Adjustable Wrench
For CATV 5/8” connector (if needed)
Small flat blade screw driver
(insulated shaft recommended)
Good to have