Installation Guide

AirStrand 1300 Installation Guide
DUG01370-SP Airspan Commercial and Internal Use 27
5.2.4 Accessing the Attenuator(s) and Test Port
Note: Opening of the maintenance cover is done in order to change the attenuators or for
connecting to a stinger connector (instead of the supplied connector).
1. Loosen the six (6) M4 screws that hold the maintenance cover in place.
Note: The screws are secured to the cover and will not fall off.
Figure 14: Removable Maintenance Cover
2. Open the removable maintenance cover and let it hang on the attached safety cable.
Note: Access to Attenuator(s) and test port are available via the Maintenance cover, see Figure 15.