Installation Instructions

3.3 Mount Sensor unit to Astro-Brac

3.3.1 Mount the SU to the Astro-Brac using the provided: 3 M6 screws,

locking washers and nuts.

3.3.2 Ensure all 3 screws are properly locked.

3.4 Connecting the Sensor Units

3.4.1 On SU with DSRC module enabled, verify that the DSRC antennas

are firmly installed. Powering on the DSRC module without

properly connecting BOTH antennas will cause permanent

damage to the unit.

3.4.1.1On SU with DSRC module enabled, connect protective earth lugs of

the antenna`s surge protector to the closest earth point on the pole,

or to protective earth of the AC cable pull.

3.4.1.2If Ethernet is available, connect Ethernet cable, ensure connector is

hermetically sealed

3.4.1.3Connect AC power cable, ensure connector is hermetically sealed

3.4.1.4Test that there is WIFI connectivity and (if available) ethernet

connectivity to the sensor unit with the help of the NoTraffic on-site

support team.

3.5 Calibrate Sensor Unit view

3.5.1.1 Move bracket to desired viewing angle

3.5.1.2 Lock bracket in place

3.5.1.3 Calibrate zoom and focus using the software setup tool, the support

is provided by on-site NoTraffic team.