Installation Instructions

2.2 Install 5-in1 antenna
2.2.1 Drill a 22 mm hole in the top of the cabinet and pass the antenna
cable assembly wiring harness through the hole from the top side.
Antenna array should be installed on one side or the other (left or
right) of the traffic cabinet to leave as much space as possible for
future additional antennas.
2.2.2 Please provide at least 8 inches (~20cm) of separation between the
antenna and the edge of the traffic cabinet.
2.2.3 Route the cable to the shelf where the control unit will be installed.
http://www.taoglas.com/wp-content/uploads/2016/05/MA450.K.LBICG
_.004.pdf
2.2.4 Remove debris from the mounting surface and place the antenna
firmly on the cabinet top using 3M adhesive.
2.2.5 Ensure a clean flat mounting surface or water leaks and
component damage will occur.
5