Installation Instructions

2.2.6 Lock antenna with included nut, recommended torque is 29.4 Nm
(21.6 lb-ft)
2.3 Control unit installation
2.3.1 Place the Control Unit on a shelf, close to the traffic controller.
Other mounting options are available upon request (such as rack
mounting).
2.3.2 Connect each antenna to the corresponding terminal of the control
unit, please note the marking next to the RF connectors.
2.3.3 Route and anchor the ethernet cable between the traffic controller
and the NoTraffic CU. Connect the ethernet cable to the left ethernet
port of the CU and the NTCIP port of the traffic controller.
2.3.4 Make sure that all antennas are properly connected. Powering
the CU fully connecting all antennas will cause permanent
damage to the control unit.
6