Use and Care Manual

22
100MM JAW SET Code: JS100N
Have an expanding dovetail grip, strong
reverse dovetail grip for footed bowls. Made for
a larger range of work than either the 50mm or
Step jaws.
25MM JAW SET Code: JS25N
Designed for small bowl (expanding dovetail
mode) and small spigot (contracting mode) free
end turning work below the size that can be
handled by the standard 50mm jaws.
35MM
& 45MM SPIGOT JAWS Code: JS
-
SP35 & JS-SP45
These two jaws provide a very powerful
contracting spigot grip with the SuperNova2
Chuck. For long unsupported spigot turning
applications.
PIN JAW SET Code: JSPIN
These special 25mm extended jaws are
designed to act like a pin chuck - expanding
into a pre-bored hole. This is a useful
technique for free form edge bowls. The real
advantage though is you don't have
to bore an exact size as with pin jaws. The
longer jaws allow for a very powerful spigot grip
for smaller work like lace bobbins etc. It also
has a small dovetail to mount small bowls.
STEP JAW SET Code: JS75N
DT
Designed primarily to grip footed bowls in the
contracting mode. Provides for optimum grip of
three different size foot diameters. Also
dovetail mode.
SPUR CENTRE Code: NSCS
This is a rugged 4 pronged spur drive with a 1
9mmsquare shank, which fits snugly into the
SuperNova2 jaws. Creep of the spur is
prevented as the shank is slotted to allow the
chuck jaws to close over it. This spur is the
answer for turners who use their
SuperNova2almost all of the time but want to
be able to do those odd spindle jobs without
removing the chuck from the lathe.