Use and Care Manual

118-0717-005 23
7. Remove the old belt and place the new belt over the Spindle End A and on to Pulley 2.
NOTE: Make sure the new Belt and Pulley 2 are all on the spindle.
8. Using a wooden mallet or plastic
hammer, start to tap the Spindle
back into the headstock.
NOTE: Before Spindle end A enters
Bearing 1, double check that the
new Belt and Pulley 2 are on the
spindle.
9. As the Spindle end A starts to enter
Bearing 1, move Pulley 2 back
along the Spindle. Gently tap the
spindle until the groove for the
Circlip 1 can be reached for
installing Circlip 1.
10. Reinstall Circlip 1.
11. On the Spindle there is a small
horizontal grove for the Pulley 2
Grub Screw to sit in. Align the grub
screw hole in Pulley 2 with this
horizontal grove and re-align the
steps of Pulley 2 with Pulley 1.
Insert Pulley 2 Grub Screw in to
Pulley 2 and tighten snug.
12. Install the belt on the slowest speed
steps, tension correctly and tighten
the motor lock handle
13. Lower and lock the cover and test
the new belt at the slowest speed at
first, to make sure Pulley 2 is not
slipping on the Spindle and that the
two pulleys are aligned correctly.
If it is slipping or the belt comes off
or starts to work its way off, repeat
step 13.
Otherwise the lathe is now ready for
use.