Installation Instructions

• Install 1” x 6” (19mm x140mm) boards over the

corner of the house. Correct out of plumb or

uneven corners at this point.

• Pre-drill a hole at a 30° downward angle in each

corner block. Align the holes towards the studs

of the wall.

• Use a 4” (100mm) long corrosion-resistant screw

to fasten each block. Apply construction adhesive

between blocks.

90º Interior Corner

Plan to make the bead of sealant the least apparent. For example, install the

brick on the wall parallel to the street all the way to the corner.

Interior corners are built using an interior corner block or by overlapping one

brick facing over the other.

• At each interior corner fasten 1” x 6” (19mm x

140mm) boards to the structural frame and cover

with a waterproof membrane.

• Use a waterproof membrane between the furring

strips and the wall to protect sheathing against

moisture.

• Install Novabrik on one wall all the way up to the

corner.

• Cut and adjust flanking pieces to achieve a

consistent 3/8” (10mm) gap.

• Once both walls are finished, insert a foam backer

rod (have the foam backer rod compressed by

50%) and apply a bead of sealant down the entire

joint between the bricks.

90º Interior Corner - Overlapping Bricks Method