Installation Instructions

Making an Arch

Arches are done by opening the

joint between two bricks at one

end. The width of the gap is

limited by aesthetics. This is why

arches are limited to openings

with a large radius.

Reducing the height of the brick

will allow for a shorter radius.

Sealing the arch

Apply a large bead of sealant between the

bricks before you set them in place with two

screws per brick. This will prevent water

penetration.

Remember to install flashing over the

opening and cover with housewrap or a

waterproof membrane.

• Prepare the opening as shown on the previous page, with a plywood

reinforcement header, housewrap and a waterproof membrane covering the

plywood and aluminum flashing.

• Start from each end, fastening each brick with 2 screws and applying a large

bead of butyl based sealant between the bricks.

• For the last brick, cut the top part and secure with

construction adhesive.

Installation on Rounded Openings

Start Start

End

Sealant