Installation Instructions

3
Step 2
Measure the height of each side (excluding gables) and multiply by the width to
obtain the surface area.
For gables, measure the height at center, add 1’ (300mm) to allow for waste, and
multiply by 1/2 of the width to obtain the surface area.
Add the areas together.
Step 3
Measure all windows, doors and any other area that will not be covered with
Novabrik. Multiply the width by the height of each area, then add the results.
Step 4
Take the result of Step 2 and subtract it from the result obtained in Step 3. Add
2% for waste. This will give you your Total Square Footage.
Multiply the Total Square Footage by the coverage factor (refer to the inside front
cover of the Installation Guide) to obtain the required number of Novabrik.
This planning guide will help you determine the amount of Novabrik and its
accessories required to complete your project. You may also refer to our estimating
sheet under the “Get A Quote” section on the Novabrik web site or on the corporate
CD-rom.
Step 1
Make sketches of the home showing all sides.
width
height
width
height
Material Take-off