Installation Instructions

36
More Tips
Installation tips
• Screw the furring strip 10” (250mm) from the bottom edge of the strip.
The bottom will be screwed in once you install the Starter Strip.
Tool tips
• A 14” blade will allow you to cut two bricks at once.
• Use two separate drills, one for screwing and the other for drilling into
the masonry.
• Have a good pair of snips to cut the trims.
• Give a firm rubber hammer strike down on a 2” x 4” setting on the bricks,
before fastening the bricks and tap the face of the bricks. This will set and
level the brick before fastening.
• Hold down the face of the brick when fastening the Novabrik. This will
prevent it from kicking out during this procedure.
• Cut and install the Novabrik in a way that the shiney side of the brick (the cut
side) is less appearent. Do the same for window sills, i.e.: the cut side into
the middle of the opening.
Correct Incorrect