Owner's Manual

Document No. 610-00-0303 Rev E.

Typical drill size is 3/8” for the #10 re-usable anchor shown. Follow manufacturer’s instructions.

For concrete or masonry wall construction

Purposed 3/16” concrete screws

Each of the two screws must be rated for 20.0 lb minimum.

Typical drill size is 5/32” for the 3/16” concrete screw. Follow manufacturer’s instructions. Follow

manufacturer’s recommendation for drill depth for screws being used.

Various types of concrete inserts are available that are adequate for use in concrete, such as conical

lead or flanged Polypropylene that will be adequate for installation of the rack mount bracket. They

must be individually rate to support 20.0 lb minimum.

Use sizes that support a #10 screw minimum.

Typical drill size is 5/16” for the #10 conical lead anchor for concrete. Follow manufacturer’s

instructions. Follow manufacturer’s recommendation for drill depth for insert being used.

Typical drill size is 1/4” for the #10 flanged Polypropylene anchor for concrete. Follow

manufacturer’s instructions for drill depth for insert being used.

For plywood wall construction

Use #10 1” screw, each of the two screws must be rated for 20.0 lbs. minimum.