Owner's Manual

Document No. 610-00-0303 Rev E.

8. Service and Maintenance Instructions

Do not open the tamper proof screws on the casing of the unit. No serviceable parts are contained

within. The units should only be opened and serviced, if necessary, by qualified Novaerus personnel.

Cleaning:

The unit should be visually inspected on a monthly basis for accumulation of dirt and dust on the

wire mesh screen that is located inside the unit chassis. The wire mesh is clearly visible from the

outside of the unit. It is recommended that the unit be cleaned using a vaccum cleaning brush from

the outside of the unit to remove any dirt and dust that may have accumulated on the wire mesh

screen.

9. Troubleshooting

Should the unit sustain severe damage and an increase in noise from the internal parts is observed,

discontinue use of the unit and contact a representative of the Novaerus technical team for

assistance. This product is not intended to be repaired in the field.

Should the unit not power on, check to ensure that the fuse located on top of the unit is secured

tightly in its socket.

10. Product Certifications

NV200: UL Listed, UL 867