User manual

5. Leave the lid open to prevent unpleasant
smells.
Important! If the cabinet will be kept on, ask
somebody to check it once in a while to
prevent the food inside from spoiling in case
of a power failure.
What to do if…
Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent
person must do the troubleshooting that
is not in this manual.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Problem Possible cause Solution
The appliance is noisy The appliance is not supported
properly
Check if the appliance stands sta-
ble (all the four feet should be on
the floor)
The compressor operates
continually
The temperature is not set cor-
rectly.
Set a warmer temperature
The lid has been opened too fre-
quently
Do not leave the lid open longer
than necessary
The lid is not closed properly Check if the lid closes well and the
gaskets are undamaged and clean
Large quantities of food to be fro-
zen were put in at the same time
Wait some hours and then check
the temperature again
Food placed in the appliance was
too warm
Allow food to cool to room tem-
perature before storing
The temperature of the room that
contains the appliance is too high
for efficient operation
Try to reduce the temperature in
the room where the appliance
stands
There is too much frost
and ice
Products are not wrapped prop-
erly
Wrap the products better
The lid is not shut properly or do
not close tightly
Check if the lid closes well and the
gaskets are undamaged and clean
The temperature is not set cor-
rectly.
Set a warmer temperature
The water drainage plug is not
correctly positioned
Position the water drainage plug in
the correct way
The lid doesn't close
completely
There is excessive frost Eliminate excess frost
The lid gaskets are dirty or sticky Clean the lid gaskets
Food packages are blocking the
lid
Arrange the packages in the right
way, see the sticker in the appli-
ance
The lid is difficult to open The lid gaskets are dirty or sticky Clean the lid gaskets
The valve is blocked Check the valve
It is too warm in the freez-
er
The temperature is not set cor-
rectly.
Set a lower temperature
The lid does not close tightly or it
is not shut properly
Check if the lid closes well and the
gasket is undamaged and clean
34