User manual

Problem Possible cause Solution
The room temperature is
too high.
Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor‐
ing.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The "FastFreeze function"
or "IntensiveCooling func‐
tion" is switched on.
Refer to "FastFreeze function"
or "IntensiveCooling function".
There is too much frost and
ice.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
Refer to "Closing the door".
Appliance is fully loaded
and it is set to the lowest
temperature
Set a higher temperature. Re‐
fer to "Operation".
Temperature set in the ap‐
pliance is too low and the
ambient temperature is
too high.
Set a higher temperature. Re‐
fer to "Operation"
Temperature is set incor‐
rectly.
Refer to "Operation" .
The compressor does not
start immediately after
pressing the "FastFreeze" or
"IntensiveCooling", or after
changing the temperature.
This is normal, no error
has occurred.
The compressor starts after a
period of time.
Water flows inside the refrig‐
erator.
Food products prevent the
water to flow into the wa‐
ter collector.
Make sure that food products
do not touch the rear plate.
The water outlet is clog‐
ged.
Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
Attach the melting water outlet
to the evaporative tray.
13