User manual

11
EN
The room temperature should correspond to the
climatic classification for which the freezer was
designed, see chapter "Technical data".
Place the freezer horizontally on a firm surface, resting
on all four feet.
For optimum operation and in order to avoid damage
when the lid is opened, leave a space of at least 5 cm
from the rear wall and 5 cm at the sides.
Before connecting the freezer to the power supply,
ensure that the voltage corresponds to that indicated
in chapter "Technical data" under "Voltage".
Danger!
Ensure that the freezer is not resting on the power
supply cable.
Do not remove the power supply cable by pulling on its
lead, particularly when the freezer is being pulled out
of its niche.
The power supply cable may only be replaced by a
qualified service personel.
Ensure that the power plug is not squashed or
damaged by the back of the freezer.
There must be adequate ventilation around the
appliance.
Any electrical work required to install this appliance
should be carried out by a qualified electrician.
Warning!
This appliance must be earthed.
First use
Before first use, the freezer should be cleaned
inside, see chapter "Care and cleaning".
Plug in the appliance.
The green light will come on.
The red light will also switch on and the alarm will
beep, since the temperature inside the freezer is
not yet sufficiently low for food storage.
Press the button to switch the alarm off. The red
light will normally switch off after several hours.
Only place food inside the freezer once the red light
has switched off.
Switch on-off
Switch on the freezer
Turn the thermostat knob to a postion between
and .
Switch off the freezer
Turn the thermostat knob to the Off position
Daily use
Temperature adjustment
To adjust the temperature of the freezer, proceed
as follows:
Turn the thermostat knob clockwise towards
for a colder storage temperature.
Turn the thermotat knob counter-clockwise
towards for a less cold storage temperature.
Super Freeze function
If more than 3-4 kg of fresh food is to be frozen, the
freezer needs to be pre-cooled.
At least 24 hours before placing fresh food in the
freezer, press button (D).
The yellow light comes on.
Place the food in the freezer. After 52 hours this
function will automatically switch off and the
freezer will return to normal storage temperature.
This function can be de-activated any time by
pressing button (D) again.
Alarm
If the freezer temperature is not cold enough, the
alarm will beep and the red light will come on.
Press button (D) to switch the sound off. The red
light remains on as long as the temperature in
the freezer is higher than the thermostat setting.
The alarm can be due to:
Insertion of a large amount of fresh food.
Opening the lid too long.
A defect in the system, see chapter "What to do
if...".
Storage baskets
Hang the baskets on the upper edge (X) or place
the stackable baskets inside the freezer (Y).
Turn and fix the handles for these two positions,
as shown in the drawings.