User manual

– Before programme is started: Appli-
ance cannot be used
– After programme is started: Pro-
gramme in operation cannot be
changed
The padlock symbol
appears in the dis-
play to indicate that the child safety device is
activated.
The child safety device is not deactivated
once the programme comes to an end.
If you want to set a new programme, you
must first deactivate the child safety device.
Starting the programme
Press the Start/Pause button (6). The pro-
gramme is started.
The programme progress is shown in LCD
by appropriate set of icons. From left to the
right, from iron dry
to anti-crease icon
depends on the drying cycle chosen. E. g. in
case of cupboard dry programme the follow-
ing status icons are visible:
.
Current cycle progress is marked by flashing
dash under status icon. When appropriate
part of drying cycle is accomplished dash
becomes steady and appears flashing under
next status icon.
Changing programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
Off (Aus) and then reset the programme.
The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob, the programme
progress display and the maintenance
indicators flash. If an option (excluding
the buzzer ) is set, Err appears in the
multidisplay. The drying programme is
not however affected by this (laundry
protection).
Programme complete / Laundry
unloading
Once the drying cycle is complete, display
shows a blinking
, under anti-crease
icon appears dash. If the buzzer option has
been set, an acoustic signal sounds intermit-
tently for about one minute.
The drying cycles (except for the Wool
(Wolle) programme) are automatically
followed by an anti-crease phase which
lasts around 30 minutes. The drum ro-
tates at intervals during this phase. This
keeps the laundry loose and free of crea-
ses. The laundry can be removed at any
time during the anti-crease phase. (The
laundry should be taken out towards the
end of the anti-crease phase at the latest
to prevent creases from forming.) If long
anti-crease
option has been set, the
anti-crease phase is lengthened by 60
minutes.
1. Open door.
2. Before removing the laundry, remove fluff
from the micro-fine filter. It is best to use
a damp hand for this purpose. (See “Care
and cleaning” chapter.)
3. Remove laundry.
4. Turn the programme selector to Off (Aus).
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter “Care and cleaning”.)
5. Close the door.
Care and cleaning
Emptying the water reservoir
Empty the water reservoir after every drying
cycle.
60