Integration Guide
Table Of Contents
- 1 Introduction
- 2 Module Power
- 3 Interfaces
- 4 Hardware Design Guidelines
- Advanced Tips for an RF-Friendly Layout
- Audio Reference Design
- Control Connector Signal Descriptions and Functions
- Module Power (PINS 87, 89, 91, 93, 95, 97, 99)
- Modem Power-on and Recovery Techniques
- Power Switch Logic Detect (Pin 85)
- ON/OFF (PIN 37)
- Phone On - PON (PIN 35)
- Internal Power Switch
- Voltage Reference - VREG_MSME1.8 (PIN 77)
- USB (PINS 1, 3, 5, 7)
- General Purpose Input/Output Interface
- RTC Sleep
- Serial Interfaces and Handshake (Pins 11, 13, 15, 17, 19, 21, 23, 25)
- UART 2 (Pins 27, 29)
- Digital Audio Interface (Pins 12, 14, 16, 18)
- 32 kHz Output (PIN 56)
- Analog-to-Digital Inputs (PIN 44 and 74)
- Handset Microphone Input (PINS 65, 67)
- Handset Microphone BIAS Output (PINS 53, 63)
- Handset Speaker Output (PINS 71, 73)
- Headset Microphone Input (PIN 55)
- Headset Speaker Output Left and Right (PINS 57, 59)
- Headset Detect (PIN 47)
- Circuit Protection
- 5 USB Driver Installation
- 54 -
Figure 5-16 Novatel Wireless M2M Driver Setup Utility Attached Devices Window
Figure 5-17 Novatel Wireless M2M Driver Setup Utility Apply Fix Window
When the installation is complete, the list of Attached Devices appears within the
Novatel Wireless M2M Driver Setup Utility Attached Devices window.