User's Manual

GPRS/EDGE PCMCIA Card Users’ Manual Page 6

Installing the PCMCIA Card into a Laptop

The EDG0200 Card is a standard Type II PCMCIA card that should work in most laptop

computers. Follow these instructions to install the card into your laptop.

1. Find the PCMCIA slot on your laptop. Typically the slot is located on the side of

your laptop.

2. Insert the EDG0200 Card into the PCMCIA slot. You should hear a tone from

your laptop when the card is seated in the slot.

To remove from the Laptop:

Follow your laptop and operating system instructions for the steps required to remove a

PCMCIA device.

Note: Some operating systems may require you to stop certain services, such as

the PCMCIA service, prior to physically removing the EDG0200 Card.

System Requirements

Check your hardware and software to see if they satisfy the requirements below. If you

are not sure, please consult your dealer or operator.

1. A valid SIM that has been data-enabled by your network operator.

2. A laptop with Windows 2000 or Windows XP and an available PCMCIA slot.

Installing mobile PhoneTools

In order use the EDG0200 Card to make an EDGE connection, you will use mobile

PhoneTools, which is provided on the CD that came with your EDG0200 Card.

Note: Install the mobile PhoneTools software before inserting the EDG0200

Card into the PC slot.

The following instructions explain how to install BVRP mobile PhoneTools on your

computer.

1. Place the Enfora CD into the CD drive of your computer.

2. You will see the BVRP/Enfora setup screen: