User's Manual
Table Of Contents
- 1 Introduction
- 2 Module Power
- 3 Physical Interfaces
- Module Mounting to Host Board (Reference)
- Connectors
- Connectors
- I/O Connector Pin Assignments
- Circuit Protection
- Antenna
- Control Connector Signal Functions
- Module Power (Pins 85, 87, 89, 91, 93, 95, 97, 99)
- Power Control (Pin 35) - (PWR_CTL)
- Level Translation Reference Power (Pin 77)
- USB (Pins 1, 3, 5, 7, 9)
- General Purpose Input/Output Interface
- RTC Sleep
- Serial Interfaces & Handshake (Pins 11, 13, 15, 17, 19, 21, 23, 25)
- Multi-Channel Serial Interface (MCSI) – (Pins 12, 14, 16, 18)
- VBackup Input (Pin83)
- Using VBackup
- Analog-to-Digital Input (Pin 74)
- Handset Microphone Input (Pins 65, 67)
- Handset Microphone Bias Output (Pin 63)
- Handset Speaker Output (Pins 71, 73)
- Headset Microphone Input (Pin 55)
- Headset Microphone Bias Output (Pin 53)
- Headset Speaker Output Left & Right (Pins 57, 59)
- Headset Output Common Mode (Pin 61)
- Headset Detect (Pin 47)
- Subscriber Identity Module (SIM) Carrier (Pins 76, 78, 80, 82, 84)
- 4 Hardware Design
- General Design Guidelines for Using Novatel Wireless M2M GSM Modules
- Enabling the Transmission Modes for the GSM/GPRS Services
- Voice Communication
- Circuit-Switched Data
- SMS: Short Message Services
- Provisioning The SIM
- GSM Services Supported by the Novatel Wireless M2M Enabler IIIG Module
- GPRS Services Supported by the Novatel Wireless M2M Enabler IIIG Module
- Selecting the GSM Modes of Operation
- 5 Setup and Initialization
- 6 Integration and Testing
xviii novatelwireless.com
Voice Communication 53
Circuit-Switched Data 53
SMS: Short Message Services 54
Provisioning The SIM 54
GSM Services Supported By The Novatel Wireless M2M Enabler IIIG Module 54
GPRS Services Supported By The Novatel Wireless M2M Enabler IIIG Module 55
Selecting The GSM Modes Of Operation 55
5 Setup And Initialization 56
General Setup 57
Hyperterminal Configuration For The Enabler IIIG Module 57
Initialization (AT Command Interface) 58
Initial Response To The AT Command 59
Sending An Initialization String To The Enabler IIIG-BGA Module 59
Setting Up The Communication Mode For The Enabler IIIG-BGA Module 60
6 Integration And Testing 61
Integrating The Novatel Wireless M2M Enabler IIIG Module 62