User's Manual
Table Of Contents
- 1 Introduction
- 2 Module Power
- 3 Physical Interfaces
- Module Mounting to Host Board (Reference)
- Connectors
- Connectors
- I/O Connector Pin Assignments
- Circuit Protection
- Antenna
- Control Connector Signal Functions
- Module Power (Pins 85, 87, 89, 91, 93, 95, 97, 99)
- Power Control (Pin 35) - (PWR_CTL)
- Level Translation Reference Power (Pin 77)
- USB (Pins 1, 3, 5, 7, 9)
- General Purpose Input/Output Interface
- RTC Sleep
- Serial Interfaces & Handshake (Pins 11, 13, 15, 17, 19, 21, 23, 25)
- Multi-Channel Serial Interface (MCSI) – (Pins 12, 14, 16, 18)
- VBackup Input (Pin83)
- Using VBackup
- Analog-to-Digital Input (Pin 74)
- Handset Microphone Input (Pins 65, 67)
- Handset Microphone Bias Output (Pin 63)
- Handset Speaker Output (Pins 71, 73)
- Headset Microphone Input (Pin 55)
- Headset Microphone Bias Output (Pin 53)
- Headset Speaker Output Left & Right (Pins 57, 59)
- Headset Output Common Mode (Pin 61)
- Headset Detect (Pin 47)
- Subscriber Identity Module (SIM) Carrier (Pins 76, 78, 80, 82, 84)
- 4 Hardware Design
- General Design Guidelines for Using Novatel Wireless M2M GSM Modules
- Enabling the Transmission Modes for the GSM/GPRS Services
- Voice Communication
- Circuit-Switched Data
- SMS: Short Message Services
- Provisioning The SIM
- GSM Services Supported by the Novatel Wireless M2M Enabler IIIG Module
- GPRS Services Supported by the Novatel Wireless M2M Enabler IIIG Module
- Selecting the GSM Modes of Operation
- 5 Setup and Initialization
- 6 Integration and Testing
57 novatelwireless.com
General Setup
The GPRS modem is controlled through the Modem RS232 port on the development board.
Connect a 9-pin straight through serial cable from the Modem RS232 connector to the serial
port on the controlling computer.
Hook up power supply, connect antenna, and install SIM into modem.
Hyperterminal Configuration For The Enabler IIIG
Module
The following provides an example for setting up a Windows HyperTerminal session that can
be used to experiment with various configurations on the module for controlling computer:
1. Select the connection interface, Direct to Com 1 (or whatever port is the serial port).
Figure 5-1 Hyper Terminal Definition
2. Configure the COM port as displayed in Figure 21.