User's Manual
Table Of Contents
- Safety Precautions
- Regulatory Compliance FCC
- Manual Overview
- Introduction
- Technical Specifications
- Physical Interfaces
- Enabler II-G Mounting Reference
- Pin Orientation Reference
- Connectors
- I/O Signal Connector on the Enfora Enabler II-G Module
- Antenna
- Control Connector Signal Descriptions and Functions
- Input Power
- Ring Indicate
- Radio Power/Reset
- Serial Interface (9 Pin I/F) (See table in section 6.5.1 I/O Connector Pin Assignments)
- General Purpose Input/Output Interface (GPIO)
- Analog-To-Digital Input
- Digital-To-Analog Output
- Handset Microphone Input
- Handset Speaker Output
- Headset Microphone Input
- Headset Speaker Output
- Audio Design Note
- Subscriber Identity Module (SIM) Carrier
- Modes of Operation
- SIM Operation
- Software Interface
- Setup and Initialization
- General Setup
- HyperTerminal Configuration for Enabler II-G
- Initialization (AT Command Interface)
- Initial Response to the AT Command
- Sending an Initialization String to the Enfora Enabler II-G Module
- Setting Up the Communication Mode for the Enfora Enabler II-G Module
- Querying the Status of the Enfora Enabler II-G Module
- Setting Module Reporting Parameters for GSM and GPRS
- GSM/SMS Examples
- GPRS Packet Examples
- General Setup
- Integration and Testing
- APPENDIX A - Warranty Repair and Return Policy
- APPENDIX B - Regulations and Compliance
- GCF Approval (Formerly FTA)
- Electromagnetic Compatibility (EMC) and Safety Requirements
- EMC/Safety Requirements for the USA
- Human Exposure Compliance Statement
- Compliance with FCC Regulations
- Unintentional Radiators, Part 15
- Intentional Radiators, Part 24
- Instructions to the Original Equipment Manufacturer (OEM)
- Nationally Recognized Testing Laboratory (NRTL) Approval
- EMC/Safety Requirements for the Countries of the European Union (EU)
- EMC/Safety Requirements for Other Countries
- APPENDIX C - Glossary and Acronyms
- APPENDIX D – Tables And Figures
- APPENDIX E - Contacting Enfora
Integration Guide
Version 1.07
GSM0100PB001 Page 58 1.07 - 1/9/04
EMC/Safety Requirements for the Countries of the European Union (EU)
The European Union (EU) is comprised of fifteen countries that follow a harmonized set of standards,
utilizing the CE mark as a uniform mark of acceptance. The member countries are:
• Austria
• Belgium
• Denmark
• Finland
• France
• Germany
• Greece
• Ireland
• Italy
• Luxembourg
• The Netherlands
• Portugal
• Spain
• Sweden
• United Kingdom
EMC/Safety Requirements for Other Countries
In most other countries that have not been listed above there are similar rules and regulations that must be
met for importing the Enfora Enabler II-G module. Each may require a different mark of approval (for
example, the CB Scheme) as an acceptance requirement. For each of these cases the country should
identified, and the appropriate steps should be taken to meet the requirements set forth in the intended
market.