User's Guide

Spider® AT
User's Guide P a g e 19 Revision: Draft
3.2 CONFIGURE THE DEVICE
Once the USB drivers are installed, and you can communicate with the Spider
Asset Tag, you can begin configuring the unit to transmit data.
There are two ways to provision the Spider Asset Tag.
1. Use a terminal emulator program to send commands to the module. (Refer
to Section 3.2.1 for more information.)
2. Use the Enfora Provisioner. (Refer to Section 3.2.2 for more information.)
Note: Before using the Enfora Provisioner to configure the device
over-the-air, basic communication parameters must be configured
using a terminal program and USB connection.
3.2.1 CONFIGURE THE SPIDER ASSET TAG MANUALLY USING A TERMINAL
EMULATOR
Any terminal emulator program such as ProComm or HyperTerminal can be used
to send AT commands to the device. Configure the terminal emulator with the
following settings:
 Baud rate is fixed at 115200
 No Parity
 8 bits
 1 stop bit
Step-by-step illustrated instructions for setting up HyperTerminal can be found in
Appendix C of this User’s Guide.
Note: Manual configuration of the device using AT commands via
USB is for advanced users and is not supported by Enfora.