Integration Guide

Table Of Contents
Enfora Enabler III LPP
Integration Guide Page 20 Revision: 0.00
5 Physical Interfaces
5.1 MODULE MOUNTING TO HOST BOARD
(REFERENCE)
TBD
5.2 I/O PIN ASSIGNMENTS
The following table shows the pin assignments for the input/output connector.
Pin #
I/O
Enabler LPP G
Description/Comments (Default
Function / Secondary Function
1 R GND System Ground
2 I BATT_TEMP Battery Temperature Input
3 I BATT_ID Battery Identification Input
4 I POWER ON/OFF Power ON/OFF control Input
5 O STATUS Power ON/OFF status Output
6 Reserved
7 Reserved
8 Reserved
9 Reserved
10 I GPI1 General Purpose INPUT 1
11 I GPI2 General Purpose INPUT 2
12 O GPO1 General Purpose OUTPUT 1
13 O GPO2 General Purpose OUTPUT 2
14 Reserved
15 Reserved
16 Reserved
17 O MSP_UART_TX UART Serial Data Output From Module
18 I MSP_UART_RX UART Serial Data Input To Module
19 O GPS_TX
UART Serial Data Output (NMEA data
only)
20 Reserved
21 Reserved
22 Reserved
23 Reserved
24 I MSP_RESET Reset Input
25 R GND System Ground
26 R GND System Ground
27 O GSM_RF_ANT GSM RF Antenna
28 R GND System Ground
29 R GND System Ground
30 P VBAT_GSM Power for GSM radio
31 P VBAT Power for non-GSM systems
32 PWR VIN Battery Charger input power supply