Integration Guide
Table Of Contents
- 1 Safety Precautions
- 2 Manual Overview
- 2.1 REFERENCES
- 2.1.1 ENFORA ENABLER III LPP PRODUCT DOCUMENTATION MANUALS
- 2.1.2 GSM DEVICE SPECIFICATIONS
- 2.1.3 FEDERAL COMMUNICATIONS COMMISSION (FCC)
- 2.1.4 FCC OFFICE OF ENGINEERING AND TECHNOLOGY (OET)
- 2.1.5 INDUSTRY CANADA
- 2.1.6 ENVIRONMENTAL REGULATIONS
- 2.1.7 MECHANICAL SPECIFICATIONS
- 2.1.8 RF AND EMI SPECIFICATIONS
- 2.1 REFERENCES
- 3 Introduction
- 4 Technical Specifications
- 5 Physical Interfaces
- 5.1 MODULE MOUNTING TO HOST BOARD (REFERENCE)
- 5.2 I/O PIN ASSIGNMENTS
- 5.3 CIRCUIT PROTECTION
- 5.4 CONTROL CONNECTOR SIGNAL DESCRIPTIONS AND FUNCTIONS
- 5.4.1 MODULE POWER (PINS 30, 31)
- 5.4.2 ON/OFF SIGNAL (PIN 4)
- 5.4.3 ON/OFF STATUS (PIN 5)
- 5.4.4 GENERAL PURPOSE INPUT SIGNALS (PINS 10, 11)
- 5.4.5 GENERAL PURPOSE OUTPUT SIGNALS (PINS 12, 13)
- 5.4.6 RESET SIGNAL (PIN 24)
- 5.4.7 USB (PINS 34, 35, 36)
- 5.4.8 SERIAL INTERFACES
- 5.4.9 HANDSET MICROPHONE INPUT (PINS 37, 38)
- 5.4.10 HANDSET SPEAKER OUTPUT (PINS 39, 40)
- 5.5 SUBSCRIBER IDENTITY MODULE (SIM) (PINS 42, 43, 44, 45, 46)
- 5.6 ANTENNA
- 6 GPS Performance
- 7 GSM/GPRS Modes of Operation
- 8 Software Interface
- 9 APPENDIX A - LIMITED WARRANTY
- 10 APPENDIX B - Regulatory Compliance
- 11 APPENDIX C - Glossary and Acronyms
- 12 APPENDIX E - Contacting Enfora
Enfora Enabler III LPP
Integration Guide Page 21 Revision: 0.00
Pin #
I/O
Enabler LPP G
Description/Comments (Default
Function / Secondary Function
33 O VIO 2.2 / 3.3 VDC Output
34 I/O USB_D- USB Data Bus (negative Terminal)
35 I/O USB_D+ USB Data Bus (Positive Terminal)
36 I USB_VBUS USB Power Supply Line
37 I MIC+ Microphone amplifier positive input
38 I MIC- Microphone amplifier negative input
39 O EAR+ Speaker positive output
40 O EAR- Speaker negative output
41 R GND System Ground
42 O SIM_RESET SIM Card Reset
43 I/O SIM_CLK SIM Card Reference Clock
44 I/O SIM_IO SIM Card I/O Data
45 PWR SIM_VDD SIM Output Voltage 1.8 V / 2.85 V
46 I SIM_DETECT SIM Card Detect
47 R GND System Ground
48 R GND System Ground
49 O GPS_RF_ANT GPS RF Antenna
50 R GND System Ground
51 RESERVED
52 RESERVED
Table 3 - Enabler III LPP Pin Assignments
I = Input into Module
P = Power Input to Module
I/O = Input/Output to/from Module
O = Output from Module R = Power Return from Module PWR = Other Power