Integration Guide
Table Of Contents
- 1 Safety Precautions
- 2 Manual Overview
- 2.1 REFERENCES
- 2.1.1 ENFORA ENABLER III LPP PRODUCT DOCUMENTATION MANUALS
- 2.1.2 GSM DEVICE SPECIFICATIONS
- 2.1.3 FEDERAL COMMUNICATIONS COMMISSION (FCC)
- 2.1.4 FCC OFFICE OF ENGINEERING AND TECHNOLOGY (OET)
- 2.1.5 INDUSTRY CANADA
- 2.1.6 ENVIRONMENTAL REGULATIONS
- 2.1.7 MECHANICAL SPECIFICATIONS
- 2.1.8 RF AND EMI SPECIFICATIONS
- 2.1 REFERENCES
- 3 Introduction
- 4 Technical Specifications
- 5 Physical Interfaces
- 5.1 MODULE MOUNTING TO HOST BOARD (REFERENCE)
- 5.2 I/O PIN ASSIGNMENTS
- 5.3 CIRCUIT PROTECTION
- 5.4 CONTROL CONNECTOR SIGNAL DESCRIPTIONS AND FUNCTIONS
- 5.4.1 MODULE POWER (PINS 30, 31)
- 5.4.2 ON/OFF SIGNAL (PIN 4)
- 5.4.3 ON/OFF STATUS (PIN 5)
- 5.4.4 GENERAL PURPOSE INPUT SIGNALS (PINS 10, 11)
- 5.4.5 GENERAL PURPOSE OUTPUT SIGNALS (PINS 12, 13)
- 5.4.6 RESET SIGNAL (PIN 24)
- 5.4.7 USB (PINS 34, 35, 36)
- 5.4.8 SERIAL INTERFACES
- 5.4.9 HANDSET MICROPHONE INPUT (PINS 37, 38)
- 5.4.10 HANDSET SPEAKER OUTPUT (PINS 39, 40)
- 5.5 SUBSCRIBER IDENTITY MODULE (SIM) (PINS 42, 43, 44, 45, 46)
- 5.6 ANTENNA
- 6 GPS Performance
- 7 GSM/GPRS Modes of Operation
- 8 Software Interface
- 9 APPENDIX A - LIMITED WARRANTY
- 10 APPENDIX B - Regulatory Compliance
- 11 APPENDIX C - Glossary and Acronyms
- 12 APPENDIX E - Contacting Enfora
Enfora Enabler III LPP
Integration Guide Page 38 Revision: 0.00
8.2 ENFORA AT COMMAND SET
For a full description of the AT commands, refer to the Enfora Enabler-LPP G AT
Command Set Reference – LPP0208AT001.
Note: A command description that includes an *asterisk
denotes that the GSM service provider must enable
supplementary servi
ces functionality before the command is
available.