Integration Guide
Table Of Contents
- 1 Safety Precautions
- 2 Manual Overview
- 2.1 REFERENCES
- 2.1.1 ENFORA ENABLER III LPP PRODUCT DOCUMENTATION MANUALS
- 2.1.2 GSM DEVICE SPECIFICATIONS
- 2.1.3 FEDERAL COMMUNICATIONS COMMISSION (FCC)
- 2.1.4 FCC OFFICE OF ENGINEERING AND TECHNOLOGY (OET)
- 2.1.5 INDUSTRY CANADA
- 2.1.6 ENVIRONMENTAL REGULATIONS
- 2.1.7 MECHANICAL SPECIFICATIONS
- 2.1.8 RF AND EMI SPECIFICATIONS
- 2.1 REFERENCES
- 3 Introduction
- 4 Technical Specifications
- 5 Physical Interfaces
- 5.1 MODULE MOUNTING TO HOST BOARD (REFERENCE)
- 5.2 I/O PIN ASSIGNMENTS
- 5.3 CIRCUIT PROTECTION
- 5.4 CONTROL CONNECTOR SIGNAL DESCRIPTIONS AND FUNCTIONS
- 5.4.1 MODULE POWER (PINS 30, 31)
- 5.4.2 ON/OFF SIGNAL (PIN 4)
- 5.4.3 ON/OFF STATUS (PIN 5)
- 5.4.4 GENERAL PURPOSE INPUT SIGNALS (PINS 10, 11)
- 5.4.5 GENERAL PURPOSE OUTPUT SIGNALS (PINS 12, 13)
- 5.4.6 RESET SIGNAL (PIN 24)
- 5.4.7 USB (PINS 34, 35, 36)
- 5.4.8 SERIAL INTERFACES
- 5.4.9 HANDSET MICROPHONE INPUT (PINS 37, 38)
- 5.4.10 HANDSET SPEAKER OUTPUT (PINS 39, 40)
- 5.5 SUBSCRIBER IDENTITY MODULE (SIM) (PINS 42, 43, 44, 45, 46)
- 5.6 ANTENNA
- 6 GPS Performance
- 7 GSM/GPRS Modes of Operation
- 8 Software Interface
- 9 APPENDIX A - LIMITED WARRANTY
- 10 APPENDIX B - Regulatory Compliance
- 11 APPENDIX C - Glossary and Acronyms
- 12 APPENDIX E - Contacting Enfora
Enfora Enabler III LPP
Integration Guide Page 2 Revision: 0.00
1.2 DISCLAIMER
The information and instructions contained within this publication comply with all
FCC, GCF, PTCRB, R&TTE, IMEI and other applicable codes that are in effect at
the time of publication. Enfora disclaims all responsibility for any act or omissions,
or for breach of law, code or regulation, including local or state codes, performed
by a third party.
Enfora strongly recommends that all installations, hookups, transmissions, etc., be
performed by persons who are experienced in the fields of radio frequency
technologies. Enfora acknowledges that the installation, setup and transmission
guidelines contained within this publication are guidelines, and that each installation
may have variables outside of the guidelines contained herein. Said variables must
be taken into consideration when installing or using the product, and Enfora shall
not be responsible for installations or transmissions that fall outside of the
parameters set forth in this publication.
Enfora shall not be liable for consequential or incidental damages, injury to any
person or property, anticipated or lost profits, loss of time, or other losses incurred
by Customer or any third party in connection with the installation of the Products or
Customer's failure to comply with the information and instructions contained herein.
Warning: The Enabler III LPP platform is designed with features
to support a robust connection. There are instances where the
module performance is beyond the control of the intended
design. Integrated designs that require 24 by 7 operation must
implement power control via an external circuit or by
implementing power management as specified within this design
guide.