User's Manual Part 1

AT Commands 45
P/N 90023363 Revision 1.8
ATP
Select pulse dialing SELECT PULSE MODE
ATQ
Set Result code presentation mode SET RESULT FORMAT
ATS0
Set number of rings before automatically answering the
call
AUTO-ANSWER THRESH-
OLD
ATS2
Modem goes from off-line to on-line data state. ESCAPRE CHARACTER
SELECTION
ATS3
Set command line termination character COMMAND LINE TERMINA-
TOR
ATS4
Set response formatting character RESPONSE FORMATTING
CHARACTER
ATS5
Set command line editing character COMMAND LINE EDITING
CHARACTER
ATS6
Set pause before blind dialing PAUSE BEFORE DIALING
ATS7
Set number of seconds to wait for connection completion CONNECTION TIMEOUT
ATS8
Set number of seconds to wait when comma dial modifier
used
COMMA CONNECTION
TIMEOUT
ATS10
Set disconnect delay after indicating the absence of data
carrier
DATA IDLE TIMEOUT
ATS12
The Escape sequence guard time selection register, S-
Register 12, is not actively used and will report a “0” when
queried. Normally the guard time is used to discriminate
between valid and invalid occurrences of the escape
sequence.
ESCAPE SEQUENCE
GUARD SELECTION
ATT
Select tone dialing SET TONE DIALING
ATV
Set result code format mode SET RESULT CODE FOR-
MAT MODE
ATX
Set connect result code format and call monitoring SET CONNECT CODE AND
CALL MONITORING
ATZ
Set all current parameters to user defined profile SET CONFIGURATION TO
USER DEFINED PROFILE
AT&C
Set DCD function mode SET DCD MODE
AT&D
Set DTR function mode SET DTR MODE
AT&F
Set all current parameters to manufacturer defaults RESTORE FACTORY
DEFAULTS
AT&V
Display current configuration DISPLAY CONFIGURATION
AT&W
Store current parameter to user defined profile SAVE CONFIGURATION
AT+DR
V.42bis data compression reporting control DATA COMPRESSION
REPORTING CONTROL
AT+DS
V.42bis data compression control DATA COMPRESSION
CONTROL
AT+GCAP
Request complete TA capabilities list CAPABILITES LIST