User's Manual Part 1

10 OEMV Family Installation and Operation User Manual Rev 5B

Notice

The following notices apply to the DL-V3, ProPak-V3, FlexPak-V2, FlexPak-V1G, FlexPak-V1, and

SMART-V1. An OEMV card might not pass emissions testing by itself. For example, the ProPak-V3

passes regulatory emissions as shown in this Notice. For more information on emissions testing,

please refer to the regulatory body in your geographic area. For example, in the US that is the Federal

Communications Commission (FCC) and in Europe the Conformité Européenne (CE).

FCC NOTICES

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the radiated and conducted emission limits

for a Class B digital device, Class A for the SMART-V1 and DL-V3, for both CISPR 22 and Part 15

of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Re-orient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

• Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected

• Consult the dealer or an experienced radio/TV technician for help

IMPORTANT: In order to maintain compliance with the limits of a Class B digital device, it

is required to use properly shielded interface cables (such as Belden #9539 or

equivalent) when using the serial data ports, and double-shielded cables (such

as Belden #9945 or equivalent) when using the I/O strobe port.

WARNING!: Changes or modifications to this equipment not expressly approved by

NovAtel Inc. could result in violation of Part 15 of the FCC rules and void the

user’s authority to operate this equipment.

RF Exposure: When using Bluetooth, the DL-V3 device exceeds the FCC requirements for

RF exposure when the antenna used for this transmitter has a separation

distance of at least 20 cm from all persons.