User's Manual Part 1

36 OEMV Family Installation and Operation User Manual Rev 5B
Chapter 3 Installation and Set Up
3.2 Installation Overview
Once you have selected the appropriate equipment, complete the following steps to set up and begin
using your NovAtel GNSS receiver.
1. Install the OEMV card in an enclosure with a wiring harness, as described in Section 3.2.1 on
Page 36.
2. Mount the GNSS antenna to a secure, stable structure, as described in Section 3.2.3 on Page 39.
3. Connect the GNSS antenna to the receiver using an antenna RF cable, using the information
given in Section 3.2.4 on Page 40.
4. Apply power to the receiver, as described in Section 3.2.5 on Page 40.
5. Connect the receiver to a PC or other data communications equipment by following the informa-
tion given in Section 3.2.6 on Page 41.
3.2.1 Installing an OEMV Card in a Wiring Harness and Enclosure
To install an OEMV card, begin with the following:
1. Ensure you are taking the necessary precautions against ESD, as described in this section below.
2. Mount the OEMV card in a secure enclosure to reduce environmental exposure and RF interfer-
ence, as described in this section in Mounting the Printed Circuit Board starting below.
3. Prepare a wiring harness to interface to the receiver’s data, status, and power signals using the
information given in Preparing the Data, Signal & Power Harness starting on Page 37.
Electrostatic Discharge (ESD) Precautions
Electrostatic discharge is a leading cause of failure of electronic equipment components and printed
circuit boards containing ESD-sensitive devices and components. It is imperative that ESD
precautions be followed when handling or installing an OEMV card. Refer to the Anti-Static Practices
section of the GPS+ Reference Manual for more information on ESD precautions.
Leave the OEMV card in its static-shielding bag or clamshell when not connected in its normal
operating environment. When removing the OEMV card from the ESD protection, follow accepted
standard anti-static practices. Failure to do so may cause damage to the OEMV card.
When you remove the OEMV card from the original packing box, it is recommended that you save the
box and ESD protection for future storage or shipment purposes.
CAUTION
• Always wear a properly grounded anti-static wrist strap when handling the OEMV card.
• Always hold the OEMV card by its corners or the RF shield, and avoid direct contact with any
of the components.
• Do not let the OEMV card come in contact with clothing at any time because the grounding strap
cannot dissipate static charges from fabrics.