User's Manual Part 1

Installation and Set Up Chapter 3

OEMV Family Installation and Operation User Manual Rev 5B 39

Figure 12: OEMV-3 Connector and Indicator Locations

Reference Description

1 P1601 power, data, and signal connector (40 pin dual row male connector

with 0.025” square pins and 0.1” spacing)

2 LED status indicator

3 J100 RF signal input and LNA power output (MMCX female connector)

4 J700 external oscillator input (MMCX female connector)

5 P1400 CAN Bus connector with transceiver

3.2.2 Mounting Bracket (DL-V3 and ProPak-V3 Only)

Along with the DL-V3 and ProPak-V3 enclosures, mounting kits are provided to facilitate mounting

the receivers to a surface.

 The mounting kits are not designed for use in high-dynamics/vibration environments. Contact

NovAtel if your application needs the DL-V3 or ProPak-V3 to be mounted in this type of

environment.

To install the mounting bracket provided with the DL-V3 or ProPak-V3, refer to the instructions

provided with the mounting kit. Page 164 provides the dimension information for the bracket.

3.2.3 Mounting the GNSS Antenna

Once the OEMV card is installed in a wiring harness and enclosure, the antenna to be used with the

receiver must be mounted. The GNSS receiver has been designed to operate with any of the NovAtel

single-frequency or dual-frequency GNSS antenna models. See Section 3.1.1 on Page 33 for more