User's Manual Part 1

Installation and Set Up Chapter 3
OEMV Family Installation and Operation User Manual Rev 5B 43
Table 7: SMART-V1 Cable Options (RS-232 only)
User-Selectable Port Configuration
The FlexPak-V1, FlexPak-V1G and FlexPak-V2 are RS-232/RS-422-selectable through pin 1 of
COM2, see Table 38, FlexPak COM2 Port Pin-Out Descriptions on Page 174 and Section A.8.2.2 on
Page 176.
The ProPak-V3 is not user-selectable but can be factory-configured on both COM1 and COM3 for
RS-232 or RS-422 operation, see Table 36, ProPak-V3 I/O Port Pin-Out Descriptions on Page 165.
The DL-V3 is RS-232 only but its COM3 port has Bluetooth/Ethernet configuration options. See DL-
Model Cables Part Numbers Connector Ends
USB SMART-V1 COM1/COM2/USB 01017893
USB: USB plug
DB9: COM1 female
COM2 female
Bare tagged wire: PWR
PWR2
GND
GND2
RESERVED
TIMEMARK
DIGITAL GND
SMART-V1 Variant 01017923
Bare tagged wire: USB
COM1
COM2
PWR
PWR2
GND
GND2
RESERVED
TIMEMARK
DIGITAL GND
CAN SMART-V1 COM1/CAN/COM3 01017894
DB9: CAN1 male
COM3 female
COM1 female
Bare tagged wire: PWR
PWR2
GND
GND2
RESERVED
TIMEMARK
DIGITAL GND
SMART-V1 Variant 01017922
Bare tagged wire: CAN1
COM3
COM1
PWR
PWR2
GND
GND2
RESERVED
TIMEMARK
DIGITAL GND