User's Manual Part 1

Installation and Set Up Chapter 3
OEMV Family Installation and Operation User Manual Rev 5B 47
Table 9: Available CAN Signals on Receivers
3.3.4 Status Indicators
OEMV family receiver cards have LED indicators that provide the status of the receiver. The OEMV
cards have a single indicator, which is shown in Figure 12 on Page 39 for the OEMV-3. The LED
blinks green on and off at approximately 1 Hz to indicate normal operation. If the indicator is red, then
the receiver is not working properly. The operation of this indicator is further described in Section 7.6
on Page 122.
The enclosures’ status indicators are shown in Tables 10 and 11 below and on Page 48. The LED
status indicators on the front of the DL-V3 are shown in Section 3.3.5 starting on Page 48.
Table 10: ProPak-V3 Status Indicators
Receiver CAN Pins/Ports
OEMV-1 and
OEMV-1G
(no transceiver)
J700
CAN1 Tx Pin 7
CAN1 Rx Pin 6
CAN2 Tx Pin 20
CAN2 Rx Pin 8
OEMV-2
(no transceiver)
P1100
CAN1 Tx Pin 19
CAN1 Rx Pin 7
OEMV-3
(with transceiver)
P1400
CAN1H Pin 2
CAN1L Pin 1
CAN2H Pin 6
CAN2L Pin 5
SMART-V1 CANH Pin 3
CANL Pin 4
Indicator Indicator Color Status
COM1 Green Data is being transmitted from COM1
Red Data is being received on COM1
COM2 Green Data is being transmitted from COM2
Red Data is being received on COM2
AUX Green Data is being transmitted from COM3
Red Data is being received on COM3
PWR Red The receiver is powered